Cleaning and Maintenance: properly clean way can increase the service life of your lighting

Lighting Cleaning frequently, it can keep the output brightness and extend the product life

Warning：It must be power off before cleaning or maintenance of the light.

How to do Lighting Cleaning and Maintenance?

1. Product cleaning
A. Clean the output acrylic board and product body every 2 weeks, or smoke dust accumulation will weaken the brightness of the light.
B. Use soft cloth with water to clean, do not with organic solvents, such as ethyl alcohol
C. Clean the cool fan each month

2. Product maintenance
Product maintenance must consider the below terms.
A. All screws mounted on the lamp must reliably tighten, check and replace the corroded screws.
B. Ensure fixed point for installation without any deformation
C. Check if the power cable is damaged and if the insulation layer is worn down.
D. To ensure good connection of the various parts of the circuit, and to avoid unnecessary accidents cursed by bad electrical connections, the detailed inspection of the light must be made by the authorized electrical engineer every three months

Quickly closed the light mode：

• Enter the menu of  “FADE”(the dimming time delay), long press the key”ENTER” for 1 second, then you  can choose the quickly closed the light, press the key of “UP” or “DOWN” to choose “YES” to open this mode, “NO” is to close the mode.
• When open the quickly closed the light mode, DMX channel signal is zero at the same time, the lighting will close immediately, other channel figures will do the CF function.

Fans control:

• Y（Warm White）when the light on, the fans will close;
• Y（Warm White）when the light off and R, G, B, W all be closed, fans will close.

More details about the Lighting Cleaning and Maintenance welcome to find in https://www.xuanfengled.com/